Nissan: Transmitter key fob

Richard wrote:
 

From someone else's previous post:

1. Close all doors and lock all doors

2. Insert and remove the key from the ignition key cylinder more than
six times within 10 seconds. (The hazard warning lamp will then flash.)
Note: Key should be withdrawn from ignition key cylinder completely
each time.

3. Insert key on ignition key cylinder and turn ignition key switch to
"AAC" position. At this time, the new ID code is entered and original
(previous) ID codes are erase.

4. Push any button on the new remote controller once. (The hazard
warning lamp will then flash) If there is only one remote controller
skip step 5.

5. Additional ID code entry, Release the door lock, then lock again with
door lock/unlock switch (In power window main switch)

6. Remove key from ignition

7. Unlock driver side door, open driver side door and then close the
door. (END)

Note:

-If you need to activate more than two additional new remote
controllers, repeat the procedure on step 5 "Additional ID code entry"
for each new remote controller.

-Entry of maximum four ID codes is allowed and any attempt to enter more
will be ignore.

Changing the batteries in the fob shouldn't require reprogramming.
Didn't on my '95 and '01 Pathfinders.

Changing the battery in the CAR does require reprogramming.

--
Chuck Tribolet
com
http://www.almaden.ibm.com/cs/people/triblet

Silicon Valley: STILL the best day job in the world.


"Richard" <com> wrote in message news:bvoh82$fvb$btinternet.com...