Ford Explorer: Explorer wont start
-
Re: Explorer wont start
Jeffrey Scholen wrote:
I have this problem with a 98 explorer. It has a 4.0 L SOHC engine,
automatic, 4wd. For me it seems to happen after the engine is warm and
it's been shut off for 10 to 15 minutes. Letting it sit for another 30
minutes or so clears up the problem.
My guess is that it has something to do with heat soak. One mechanic
suggested a bad coil pack. Another suggested the fuel pump. The former
makes more sense to me since it could be affected by the engine temp.
Haven't replaced it yet. It's beginning to cool down here in Minnesota,
so I may be able to put it off for a while.
Larry
-
Re: Explorer wont start
out of gas?
--
---------------------------------------------------------------------
"Are you still wasting your time with spam?...
There is a solution!"
Protected by GIANT Company's Spam Inspector
The most powerful anti-spam software available.
http://www.giantcompany.com
"ldwhitley at charter dot net" <"ldwhitley at charter dot net"> wrote in
message news:supernews.com...
in
-
Re: Explorer wont start
Are you saying that it won't crank at all, or it won't start? If it
cranks but won't start, could be the idle air control valve problem.
Easy way to check for that is to press down on the gas pedal and see
if it starts then.
On Mon, 01 Sep 2003 08:40:26 -0500, "ldwhitley at charter dot net"
<"ldwhitley at charter dot net"> wrote:
-
wideglide01diespammers@cox.net
Guest
Re: Explorer wont start
A hush fell over the crowd when, "ldwhitley at charter dot net"
<"ldwhitley at charter dot net"> stepped up to the podium and
announced:
check your crank angle position sensor. Both of your symptoms
indicate that's the problem.
************************************************** ********************
People are more violently opposed to fur than leather because it's
safer to harass rich women than motorcycle gangs.
-Unknown
Remove "die spam" to email
-
Re: Explorer wont start
I solved the problem by removing the crank position sensor and putting it
back on. There's only 1.5 dcv going to this sensor, so when it corrodes, the
engine will just spin. wiggling the connector will probably work also.
Jeff
"ldwhitley at charter dot net" <"ldwhitley at charter dot net"> wrote in
message news:supernews.com...
in
-
Re: Explorer wont start
I had the same problem with my 96 Explorer. It was the fuel pump relay. It
toke about 2 months to fine what the trouble was. Next time when your
engine won't start look under the hood for the fuses there (by the brake
master cylinder), you will see 3 1 inch square relays, just rotate the 3 of
them around and see if the engine starts
Ron
"ldwhitley at charter dot net" <"ldwhitley at charter dot net"> wrote in
message news:supernews.com...
in
-
Re: Explorer wont start
ldwhitley at charter dot net wrote:
Thought I'd post the answer.
One morning we started the truck and while it started, it was missing
and stumbling heavily. Decided not to drive it that day. The next day,
tried it again, wouldn't start at all - cranked but would not catch.
Certainly no heat-soak involved so my theory blaming the coil pack was
out the window.
When monday came I had it towed to the Ford place. They diagnosed a bad
fuel pump. They replaced it and the problem is fixed. (Fortunately, it
was under the extended warrenty so I only had to pay the deductable.)
Looking back, its clear now that there was one more symptom that I
hadn't noted. Even when the truck started, it was slower to start.
That is, it didn't fire up as quicly as it normally did, but took a few
seconds of cranking before it would catch. With the new fuel pump it
fires up very quickly.
Larry
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules