Reply With Quote"ignatz" <com> wrote in message
news:talkaboutautos.com...
There's only a small amount of free lever movement before the release
bearing hits the pressure plate. There after the pressure plate provides the
return action. Try it with the cable. The pedal has to be FULLY depressed to
disengage the clutch. If the level still sticks then it likely that the
release bearing is jammed on the spigot shaft tube: fixing this requires the
transmission to be removed from the engine.
Stewart DIBBS
www.vysor.com/lancerproject
+ Reply to Thread
Results 1 to 3 of 3
Mitsubishi: clutch-1993 Eagle Summit - Mitsubishi-arm sticking
-
LinkBack
LinkBack URL
About LinkBacks- Bookmark & Share
- Add Thread to del.icio.us
- Tweet this thread
- 11-24 02:25 AM #1ignatzGuest
clutch-1993 Eagle Summit - Mitsubishi-arm sticking
Hi! Just got a 93 Eagle Summit which is a Mitsubishi, I believe. Clutch was
sticking - found the cable to be sticking. After disconnecting, found the
arm also stuck. (it had been sitting awhile). After much work,(and lots of
Liquid Wrench), got it freed up a bit but still, in my opinion not enough
to work with the new cable. Any ideas on how to free the arm up enough to
work, or is this a major repair? It is a 5-speed, and 1.5L. 4 cyl. motor.
Any help is greatly appreciated. bob dobush
- 11-24 11:25 PM #2StewartGuest
Re: clutch-1993 Eagle Summit - Mitsubishi-arm sticking
- 11-26 03:20 AM #3ignatzGuest
Re: clutch-1993 Eagle Summit - Mitsubishi-arm sticking
Hi! Thanks for the info - I will put the cable in and try it and see if the
pedal returns when releasing, which it didnt do before. bob d.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts