Reply With QuoteFactory manual should show wiring and pin-outs for "with" and
"without" information display in overhead console configurations.
Take the existing console out. If the factory wiring for the OHC
data bus is up in the headliner but taped back (for example, on
the 1998, "with" uses a red connector whereas "without" uses a
blue connector) as it is with some trim versions, it is a near
plug-n-play situation (some pin-outs likely differ). If not, I
would not even know where to start, to find all the proper
signaling.
- Bob
Chester wrote:
+ Reply to Thread
Results 1 to 3 of 3
Chrysler: 2000 Dodge Caravan Overhead Console Retrofit
-
LinkBack
LinkBack URL
About LinkBacks- Bookmark & Share
- Add Thread to del.icio.us
- Tweet this thread
- 09-15 03:27 PM #1ChesterGuest
2000 Dodge Caravan Overhead Console Retrofit
I've purchased an overhead console with the vehicle information
display and temperature sensor for in front of the grill. I was
hoping it'd be as simple as attaching the CCD bus and power, but
there's more wiring than that. Does anyone have a schematic for
the connectors on this unit? The console is from a 2000 Town and
Country.
- 09-15 08:49 PM #2RWMGuest
Re: 2000 Dodge Caravan Overhead Console Retrofit
- 09-16 09:20 AM #3BillGuest
Re: 2000 Dodge Caravan Overhead Console Retrofit
Chester wrote:
For $25 for a years subscription, you can have access to the wiring
diagrams (and other info.) right out of the factory shop manuals on-line
thru www.alldata.com. I'm finding that to be a great resource in lieu
of the shop manuals.
Bill Putney
(to reply by e-mail, replace the last letter of the alphabet in my
address with "x")
-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts