Subaru: 1997 GT - Blinking lights after changing battery

Hi there,

I have a stomper. I just bought this 1997 GT and was told that it did not
have a Keyless Entry System or remotes. Anyway, I replaced the battery and
when I put it in the lights started blinking outside and inside the car. The
lights will blink four or five times, then stop for about 5 or 7 seconds and
do it all over again. I followed the clicking sound under the dash and
found a "Keyless Entry Control Unit" there. I guess there are some things
that I was not told about and find out slowly.

The problem is - how do I stop the blinking lights? I had to disconnect the
battery since I was not sure what to do. I am not driving the car yet since
it is not registered but would like to clean it and get these bugs out of
the system before taking it out.

Any help would be greatly appreciated.

Thanks

--

Manny Ramos
Centennial, CO

This actually sounds like an aftermarket unit, (omega, code alarm, possibly
lojack) There generally was a overide switch, black button, silver toggle,
could even be a window, high beams, rear defroster....

The alarm system was probably pulled by the dealer as they did not have
programmable remotes for the unit, check to see if there are any numbers
model, serial that are on the keyless module. Go to a local alarm shop and
check what make and if they can get the remotes? is all the hardware there?
or can they remove all the remaining hardware.

Marc
"Shamus in CO" <com> wrote in message
news:com... 
battery 
car. 
seconds 
and 
disconnect 
to 
the