+ Reply to Thread
Results 1 to 4 of 4

Toyota Camry: 1996 Camry Transmission overfill

  1. #1
    me
    Guest

    1996 Camry Transmission overfill

    I slightly overfilled the tranny fluid on 1996 Camry - it is slightly higher
    than the HOT area of the dipstick - put 30 miles on the car since - did I
    damage the transmission already -- any help would be appreciated?



  2. #2
    me
    Guest

    Re: 1996 Camry Transmission overfill

    it is .25 inch higher than the HOT mark on the dip stick



  3. #3
    M.J.S.
    Guest

    Re: 1996 Camry Transmission overfill

    Should be no problem. There is a relief valve on the transmission. If the
    fluid expands too much, it leaks out. I once drove a 95 Avalon from Ontario
    to Florida with a extra quart installed (by the dealer) and other than
    leaking all over the I75, no problem.......



  4. #4
    Daniel
    Guest

    Re: 1996 Camry Transmission overfill

    "me here" <com> wrote in message news:<t6_Mb.7267$Ar1.3425@fed1read04>... 

    I suspect automatic transmissions are routinely over filled because
    some service personnel do not allow the unit to reach full operating
    temperature before checking.
    The fluid needs to be "hot" which according to Toyota takes minimum
    ten miles driving time.
    When the fluid is fully warmed or heated and has expanded, then one
    checks the final level on the dipstick.
    So a lot of people - certainly the ones who have had their transaxles
    serviced at Jiffy Lube (drive around the block then re check) - a lot
    of people are driving around with over filled transmissions - and it
    doesn't seem to do a lot of harm.
    Don't think it does any good either, though.
    Transmissions are expensive, and for me, I keep the level at the
    correct mark.
    If you're regularly changing the transmission fluid, as you should be,
    you may inadvertently overfill slightly.
    Here's my solution:
    AutoZone sells a simple siphon tube kit with a small plastic squeeze
    bottle.
    It doesn't really work, but only costs around $2. The little squeeze
    bottle just crushes and that's the end of it. But you also get a nice
    new, clean, long, narrow plastic tube which fits nicely into the
    transmission fill tube.
    This may not be the recommended method, but I just suck out the fluid
    into the tube, being careful the red liquid does not reach my mouth,
    then empty into a container by putting my finger over the end and then
    releasing.
    Once or twice ought to do it for .25".
    Then store the tube in a sealed plastic bag. Automatic transmissions
    are very sensitive to contamination so you don't want to introduce any
    dirt or grit next time.
    Chances are, after having done this once, you'll be less likely to
    overfill again, but if needed, can adjust the level perfectly.
    I always figure the marks on the dipstick were put there for a reason,
    may as well use them.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Search Engine Friendly URLs by vBSEO 3.6.0

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48